hoan.uk

J-pole antenna lab

Antennas

About

ToolIntermediateAges 14–998 minITU-ARRL RF-TECH-03GDPT-2018 VatLi-11

Choose a frequency and conductor and read off the radiator, matching stub, spacing and feed tap height of a J-pole.

Steps

0 of 4 done

How it works

J-Pole construction and coaxial connection guide

1. 50Ω coaxial feedline connection

Connect the centre conductor (signal) of the 50Ω coaxial cable to the long element (radiator A) and the outer shield (ground) to the short element (matching stub B) at tap height C from the bottom shorting bar. Use adjustable metal hose clamps to slide the feedpoint up or down and trim for a perfect 1:1 SWR before final soldering.

2. Materials and mast grounding

Commonly built from 1/2" or 3/4" copper pipe or aluminium tubing. The bottom shorting bar D connects both legs and can be bolted directly to a grounded metal mast without insulators, as the bottom centre point has zero RF voltage (virtual ground).

J-Pole antenna theory and operation

The J-Pole antenna (often called the J-Antenna) is an omnidirectional vertical antenna with a half-wave (λ/2) radiating element matched to a 50 Ohm feed line by a quarter-wave (λ/4) shorted transmission-line stub. The name comes from its J-shaped silhouette: a long radiator pole and a parallel short stub joined at the base by a shorting bar.

Because it is an end-fed half-wave antenna, it has a very low take-off angle towards the horizon, which makes it an excellent choice for local VHF/UHF amateur radio, repeater operation and emergency packet networks.

J-Pole design advantages

The J-Pole needs no ground radials (unlike a standard ground plane antenna), is very rugged when built from copper pipe, and can be mounted directly on a metal mast. Grounding the bottom shorting bar does not affect performance, since it is a point of zero RF voltage.

Impedance matching and feeding

The quarter-wave matching stub at the bottom acts as an impedance transformer (shorted at the bottom, open at the top). Feeding the coax at the right height matches the standard 50 Ohm coax impedance, so the active half-wave section above can radiate efficiently.

SWR troubleshooting and common-mode chokes

High SWR on a J-Pole is usually caused by common-mode RF current flowing down the outer coax shield. Fix it with an RF choke (balun) of 4 to 6 turns of the coax in a 10 cm coil placed right at the feedpoint.

Quiz

What is the job of the short stub in a J-pole?
Where does a vertical J-pole radiate best?
How do you tune the SWR of a J-pole?
Element cut list and specifications (J-Pole)
ElementLengthNote
Long element overall (A)1,505.2 mmTotal length of the long copper pole (3/4 λ).
Stub element overall (B)501.7 mmLength of the shorter parallel matching stub (1/4 λ).
Active radiator section (A - B)1,003.4 mmThe top half-wave radiator section that actually radiates the signal.
Coaxial feedpoint height (C)100.3 mmHeight from the bottom of the shorting bar to the point where the coax centre and shield connect.