hoan.uk

Yagi antenna lab

Antennas

About

ToolAdvancedAges 15–998 minITU-ARRL RF-TECH-05AP Physics-2:Waves

Choose a frequency, conductor and number of elements and read off every element length and boom position of a DL6WU Yagi-Uda beam.

Steps

0 of 4 done

How it works

Yagi Assembly Instructions

1. Dipole Feeding & Matching

The driven element should be split in the middle (leaving a 4-5 mm gap) and connected to the center conductor and braid of a 50Ω coaxial cable. An RF choke (balun) made of 4-5 turns of coax is recommended near the feedpoint.

2. Boom Isolation

If using a metal boom, elements should be insulated from the boom or compensated for boom correction. For a non-conductive boom (PVC, fiberglass, wood), elements can pass directly through holes without any compensation.

Yagi-Uda Antenna Theory & Calibration

Yagi-Uda antenna (commonly known as a Yagi) is a highly directional antenna widely used in amateur radio, television reception, and satellite communication. Designed in 1926 by Shintaro Uda and Hidetsugu Yagi, it offers significant directional gain by utilizing a single active element (the driven element) coupled with several passive elements (a reflector and one or more directors).

Reflector Element

Typically 5% longer than the driven element, placed behind it. It reflects RF energy forward, acting like a mirror.

Driven Element

The active dipole connected to the receiver/transmitter coax, cut to approximately a half-wavelength (λ/2).

Director Elements

Slightly shorter (approx. 5% shorter per director) placed in front of the driven element to focus the beam forward.

Technical Guidelines & Reference

Yagi Antenna Gain Optimization

Yagi antenna gain is primarily determined by the length of the boom, not just the number of elements. Adding more director elements on a longer boom increases forward directivity and narrows the beamwidth, resulting in higher gain.

Velocity Factor (VF) Compensation

Radio waves travel slower through metal conductors than they do in free space. The Velocity Factor (VF) compensates for this slowdown. Standard values range from 0.95 for telescoping whips to 0.97 for copper pipes. Failing to apply the correct VF shifts the resonant frequency lower.

Coaxial Connection & Balun

A standard split-dipole driven element has a feedpoint impedance of roughly 72 Ohms in free space, which drops to around 50 Ohms when placed in a Yagi array. You can connect standard 50 Ohm coaxial cable (like RG-58) directly. To avoid common-mode currents, wrap the coax 4-5 times in a 5cm loop just before the feedpoint to form a simple air-core 1:1 balun (RF choke).

Quiz

Which element of a Yagi is connected to the feedline?
In which direction does a Yagi radiate most strongly?
What happens to the boom length when you add a director?

Element Cut List & Boom Positions Yagi-Uda

Spacing positions start at 0.0 mm at the rear Reflector. Hover over a row to highlight the element in the 3D model.

Element NameTotal LengthHalf Length (Cut)Position on Boom
Reflector344.1 mm172.1 mm0 mm
Driven element329.8 mm164.9 mm107.1 mm
Director 1308.4 mm154.2 mm214.2 mm
Director 2305.6 mm152.8 mm342.7 mm
Director 3299.9 mm149.9 mm485.5 mm