hoan.uk

Cantenna

Antennas

About

ToolIntermediateAges 14–998 minITU-ARRL RF-TECH-01NGSS HS-PS4-5

A metal can acts as a circular waveguide. Choose a frequency and can diameter to see the TE11 and TM01 cutoffs, the guide wavelength, where to place the quarter-wave probe, and the forward lobe.

Steps

0 of 4 done

How it works

Step-by-step cantenna construction guide

  1. Prepare the metal can: Choose a smooth, seamless round metal can with a solid flat bottom (for example a coffee tin, pineapple juice can or metal paint can). Clean and dry it thoroughly.
  2. Drill the feed connector hole: Measure exactly S = 62.1 mm from the inside surface of the closed flat bottom. Drill a neat hole matching the N-type or SMA chassis-mount connector barrel.
  3. Solder the monopole probe: Use 1.5 - 2.5 mm solid copper wire soldered directly to the centre pin of the N-chassis connector. Cut the probe protruding into the cavity to exactly L_probe = 29.2 mm, measured from the inner wall.
  4. Mount and secure the connector: Bolt the four chassis mounting holes or tighten the retaining nut securely, so the connector makes a solid 360-degree RF ground bond with the metal can.
  5. Orientation and polarization: Aim the open mouth directly at the target Wi-Fi router, drone or satellite. Keep the can horizontal with the probe standing vertically for standard vertical polarization.

Quiz

What happens if the frequency is below the TE11 cutoff?
How far from the closed back is the probe placed?
Why avoid frequencies above the TM01 cutoff?
Feed placement (S)62.1 mmλg / 4 from the closed bottom
Probe pin length29.2 mmQuarter wave, λ₀ × VF
Estimated gain~8 dBiBeamwidth ~82°
Guide wavelength (λg)248.4 mmFree-space λ₀: 123 mm
Fabrication specifications and cut list
ComponentSymbolFormula / definitionDimension
Can inside diameterDDirect inside measurement83 mm
Feed hole centre from bottomSλg / 4 (in-phase reflection distance)62.1 mm
Copper probe pin lengthL_probe0.25 × λ₀ × VF (from the inner can wall)29.2 mm
Recommended minimum can lengthL_can≥ S + 0.75 × λg (ideally ≥ 1 λg)248.4 mm
TE₁₁ dominant mode cutofffc(TE₁₁)c / (1.706 × D)2,117.2 MHz
TM₀₁ second mode cutofffc(TM₀₁)c / (1.306 × D)2,765.7 MHz